Firebird Nation banner
Cancel

Brake booster pin

225 Views 8 Replies 3 Participants Last post by  Mike78, 
M
Hi there, new here, searched but couldn't find an answer.

Changing my master cylinder and the gap between the booster pin and master is too large, my pin is a solid pin with no adjustment. Couldn't find an adjustable one after a quick search, any suggestions?

Much appreciated

Mike
Reply
Save
Like
1 - 2 of 9 Posts
A
Don't forget to remove the insert, that's come up before when one guy said it was too short and also wouldn't seat very well.
Reply
Save
Like
A
I think it's like a packaging seal, to keep pin from falling out in transit. It was in a post a few years ago.
Reply
Save
Like
  • Like
Reactions: 1
1 - 2 of 9 Posts
Firebird Nation
A forum community dedicated to Pontiac Firebird owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Open Discussions Fourth Generation Pontiac Firebird (1993 - 2002) Second Generation Pontiac Firebird (1970 - 1981) Introductions and Staff Photos General Engine (Non-Gen Specific)
Top