Firebird Nation banner
Cancel

Brake booster pin

226 Views 8 Replies 3 Participants Last post by  Mike78, 
M
Hi there, new here, searched but couldn't find an answer.

Changing my master cylinder and the gap between the booster pin and master is too large, my pin is a solid pin with no adjustment. Couldn't find an adjustable one after a quick search, any suggestions?

Much appreciated

Mike
Reply
Save
Like
1 - 5 of 9 Posts
M
Appreciate the feedback and detail. Thank you.

I measured and its 5 mm off so way too big a gap. I removed the pin and its a solid piece, no adjustment at all.
Reply
Save
Like
M
Found an adapter
gap is now .055 inches
Reply
Save
Like
M
Aus78Formula said:
Don't forget to remove the insert, that's come up before when one guy said it was too short and also wouldn't seat very well.
Click to expand...
Inserts?
Reply
Save
Like
M
Actually there was no pin / adapter in the MC when I took it out which explains a lot.
Reply
Save
Like
1 - 5 of 9 Posts
Firebird Nation
A forum community dedicated to Pontiac Firebird owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Open Discussions Fourth Generation Pontiac Firebird (1993 - 2002) Second Generation Pontiac Firebird (1970 - 1981) Introductions and Staff Photos General Engine (Non-Gen Specific)
Top