Firebird Nation banner
1 - 4 of 4 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
I need help with this issue please !! I have bought new axles, third member etc. I have gone through 3 sets of the sealed bearings trying to get them to sit flush against the axle housing. Every bearing fits od and id but the width is the issue. It sticks out approx. 1/16th from the housing . Both axles have plenty of room to go further into the axle but the machined surface inside housing is only allowing it to go so far . The housing is correct for the car via number's matching. It has got me stumped !! Any help please??? Has anyone had this issue ?
 

·
']['exXxas']['itan
Joined
·
759 Posts
Photos of the inside of the axle tube flange?
 
1 - 4 of 4 Posts
Top